Hovercraft - first trials

The final building steps

	The craft after priming and adding the tail
Detail from the lift motor and intake

Frontal closeup from the tail and servo mount

Rear view with tail; just visible: rudder pivots

Then, finally it was finished far enough to take it for a first spin!

Preparing the hovercraft for the first trial run: professionally attaching the lift intake cover (duct tape...)

Taking off for the first time!

Nicely cruising by...

Look! It's actually blowing air from under the trash bag... ehh, skirt!

This site is sponsored by:

2 Brothers R/C, Bussum.